545-208
Electronic To Pneumatic Transducer
by
done_outline8888 in stock
addShow Locations
removeHide Locations
0 To 10 VDC Input Signal, 0 To 20 psig Output Signal, Remote Mount.
Features
Insensitive To Vibration And Mounting Position To Allow Mounting Directly On Equipment And Give Stable Performance
Hand-Auto Switch And Override Dial Allow For Manual Control Of Output Pressure For Troubleshooting And Emergencies
Optional Electrical Connections To Remotely Monitor Hand-Auto Switch Position And Output Pressure
Accurate And Repeatable Output Pressure Signal
Easy To Install, No Setup Or Calibration Is Required
The Unit Can Be Mounted Directly On The Wall Or Equipment Without An Additional Enclosure To Reduce Cost
Factory Installed 0 To 30 psi Gauge Is Included
High Capacity, Non-Bleed Device